diff options
Diffstat (limited to 'Documentation/howto/isolate-bugs-with-bisect.txt')
| -rw-r--r-- | Documentation/howto/isolate-bugs-with-bisect.txt | 65 |
1 files changed, 0 insertions, 65 deletions
diff --git a/Documentation/howto/isolate-bugs-with-bisect.txt b/Documentation/howto/isolate-bugs-with-bisect.txt deleted file mode 100644 index 926bbdc3cb..0000000000 --- a/Documentation/howto/isolate-bugs-with-bisect.txt +++ /dev/null @@ -1,65 +0,0 @@ -From: Linus Torvalds <torvalds () osdl ! org> -To: git@vger.kernel.org -Date: 2005-11-08 1:31:34 -Subject: Real-life kernel debugging scenario -Abstract: Short-n-sweet, Linus tells us how to leverage `git-bisect` to perform - bug isolation on a repository where "good" and "bad" revisions are known - in order to identify a suspect commit. - - -How To Use git-bisect To Isolate a Bogus Commit -=============================================== - -The way to use "git bisect" couldn't be easier. - -Figure out what the oldest bad state you know about is (that's usually the -head of "master", since that's what you just tried to boot and failed at). -Also, figure out the most recent known-good commit (usually the _previous_ -kernel you ran: and if you've only done a single "pull" in between, it -will be ORIG_HEAD). - -Then do - - git bisect start - git bisect bad master <- mark "master" as the bad state - git bisect good ORIG_HEAD <- mark ORIG_HEAD as good (or - whatever other known-good - thing you booted last) - -and at this point "git bisect" will churn for a while, and tell you what -the mid-point between those two commits are, and check that state out as -the head of the new "bisect" branch. - -Compile and reboot. - -If it's good, just do - - git bisect good <- mark current head as good - -otherwise, reboot into a good kernel instead, and do (surprise surprise, -git really is very intuitive): - - git bisect bad <- mark current head as bad - -and whatever you do, git will select a new half-way point. Do this for a -while, until git tells you exactly which commit was the first bad commit. -That's your culprit. - -It really works wonderfully well, except for the case where there was -_another_ commit that broke something in between, like introduced some -stupid compile error. In that case you should not mark that commit good or -bad: you should try to find another commit close-by, and do a "git reset ---hard <newcommit>" to try out _that_ commit instead, and then test that -instead (and mark it good or bad). - -You can do "git bisect visualize" while you do all this to see what's -going on by starting up gitk on the bisection range. - -Finally, once you've figured out exactly which commit was bad, you can -then go back to the master branch, and try reverting just that commit: - - git checkout master - git revert <bad-commit-id> - -to verify that the top-of-kernel works with that single commit reverted. - |