| Age | Commit message (Collapse) | Author |
|---|
|
"git worktree add" takes special care to avoid creating a new worktree
at a location already registered to an existing worktree even if that
worktree is missing (which can happen, for instance, if the worktree
resides on removable media). "git worktree move", however, is not so
careful when validating the destination location and will happily move
the source worktree atop the location of a missing worktree. This leads
to the anomalous situation of multiple worktrees being associated with
the same path, which is expressly forbidden by design. For example:
$ git clone foo.git
$ cd foo
$ git worktree add ../bar
$ git worktree add ../baz
$ rm -rf ../bar
$ git worktree move ../baz ../bar
$ git worktree list
.../foo beefd00f [master]
.../bar beefd00f [bar]
.../bar beefd00f [baz]
$ git worktree remove ../bar
fatal: validation failed, cannot remove working tree:
'.../bar' does not point back to '.git/worktrees/bar'
Fix this shortcoming by enhancing "git worktree move" to perform the
same additional validation of the destination directory as done by "git
worktree add".
While at it, add a test to verify that "git worktree move" won't move a
worktree atop an existing (non-worktree) path -- a restriction which has
always been in place but was never tested.
Signed-off-by: Eric Sunshine <sunshine@sunshineco.com>
Signed-off-by: Junio C Hamano <gitster@pobox.com>
|
|
"git checkout --no-overlay" can be used to trigger a new mode of
checking out paths out of the tree-ish, that allows paths that
match the pathspec that are in the current index and working tree
and are not in the tree-ish.
* tg/checkout-no-overlay:
revert "checkout: introduce checkout.overlayMode config"
checkout: introduce checkout.overlayMode config
checkout: introduce --{,no-}overlay option
checkout: factor out mark_cache_entry_for_checkout function
checkout: clarify comment
read-cache: add invalidate parameter to remove_marked_cache_entries
entry: support CE_WT_REMOVE flag in checkout_entry
entry: factor out unlink_entry function
move worktree tests to t24*
|
|
The 'git worktree' command used to be just another mode in 'git
checkout', namely 'git checkout --to'. When the tests for the latter
were retrofitted for the former, the test name was adjusted, but the
test number was kept, even though the test is testing a different
command now. t/README states: "Second digit tells the particular
command we are testing.", so 'git worktree' should have a separate
number just for itself.
Move the worktree tests to t24* to adhere to that guideline. We're
going to make use of the free'd up numbers in a subsequent commit.
Signed-off-by: Thomas Gummerer <t.gummerer@gmail.com>
Signed-off-by: Junio C Hamano <gitster@pobox.com>
|
