diff options
Diffstat (limited to 'resources/definitions/fdmprinter.def.json')
-rw-r--r-- | resources/definitions/fdmprinter.def.json | 4 |
1 files changed, 1 insertions, 3 deletions
diff --git a/resources/definitions/fdmprinter.def.json b/resources/definitions/fdmprinter.def.json index 325e4b6c79..c015ab8ccb 100644 --- a/resources/definitions/fdmprinter.def.json +++ b/resources/definitions/fdmprinter.def.json @@ -2406,7 +2406,7 @@ "switch_extruder_retraction_amount": { "label": "Nozzle Switch Retraction Distance", - "description": "The amount of retraction: Set at 0 for no retraction at all. This should generally be the same as the length of the heat zone.", + "description": "The amount of retraction when switching extruders. Set to 0 for no retraction at all. This should generally be the same as the length of the heat zone.", "type": "float", "unit": "mm", "enabled": "retraction_enable", @@ -4456,7 +4456,6 @@ "description": "Amount of offset applied to the roofs of the support.", "unit": "mm", "type": "float", - "minimum_value": "0", "default_value": 0.0, "value": "extruderValue(support_roof_extruder_nr, 'support_interface_offset')", "maximum_value": "extruderValue(support_extruder_nr, 'support_offset')", @@ -4471,7 +4470,6 @@ "description": "Amount of offset applied to the floors of the support.", "unit": "mm", "type": "float", - "minimum_value": "0", "default_value": 0.0, "value": "extruderValue(support_bottom_extruder_nr, 'support_interface_offset')", "maximum_value": "extruderValue(support_extruder_nr, 'support_offset')", |