From 268d16ca34421494aae575306458f5aed122a03a Mon Sep 17 00:00:00 2001 From: Ghostkeeper Date: Wed, 2 Feb 2022 15:44:20 +0100 Subject: Update default_values to be equal to the new values This helps when testing CuraEngine via command line. --- resources/definitions/fdmprinter.def.json | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) diff --git a/resources/definitions/fdmprinter.def.json b/resources/definitions/fdmprinter.def.json index e32a35ad3c..83f8b69565 100644 --- a/resources/definitions/fdmprinter.def.json +++ b/resources/definitions/fdmprinter.def.json @@ -1107,7 +1107,7 @@ "description": "The smallest line width, as a factor of the normal line width, above which the middle line (if there is one) will be split into two. Reduce this setting to use more, thinner lines. Increase to use fewer, wider lines. Note that this applies -as if- the entire shape should be filled with wall, so the middle here refers to the middle of the object between two outer edges of the shape, even if there actually is fill or (other) skin in the print instead of wall.", "type": "float", "unit": "%", - "default_value": 50, + "default_value": 90, "value": "wall_transition_threshold", "minimum_value": "1", "maximum_value": "99" @@ -1117,7 +1117,7 @@ "description": "The smallest line width, as a factor of the normal line width, above which a middle line (if there wasn't one already) will be added. Reduce this setting to use more, thinner lines. Increase to use fewer, wider lines. Note that this applies -as if- the entire shape should be filled with wall, so the middle here refers to the middle of the object between two outer edges of the shape, even if there actually is fill or (other) skin in the print instead of wall.", "type": "float", "unit": "%", - "default_value": 50, + "default_value": 80, "value": "wall_transition_threshold * 8 / 9", "minimum_value": "1", "maximum_value": "99" -- cgit v1.2.3