Slic3r has been modified to propagate the following filament specific

values to GCode generator, one per active extruder:

bed_temperature
bridge_fan_speed
cooling
disable_fan_first_layers
fan_always_on
fan_below_layer_time
first_layer_bed_temperature
max_fan_speed
min_fan_speed
min_print_speed
slowdown_below_layer_time

Now it remains to extend Slic3r to correctly apply these values.

1 files changed, 3 insertions, 3 deletions

diff --git a/t/skirt_brim.t b/t/skirt_brim.t
index 878a78840..7a4507942 100644
--- a/t/skirt_brim.t
+++ b/t/skirt_brim.t
@@ -18,7 +18,7 @@ use Slic3r::Test;
     $config->set('skirt_height', 2);
     $config->set('perimeters', 0);
     $config->set('support_material_speed', 99);
-    $config->set('cooling', 0);                     # to prevent speeds to be altered
+    $config->set('cooling', [ 0 ]);                 # to prevent speeds to be altered
     $config->set('first_layer_speed', '100%');      # to prevent speeds to be altered
     
     my $test = sub {
@@ -52,7 +52,7 @@ use Slic3r::Test;
     $config->set('bottom_solid_layers', 0);         # to prevent solid shells and their speeds
     $config->set('brim_width', 5);
     $config->set('support_material_speed', 99);
-    $config->set('cooling', 0);                     # to prevent speeds to be altered
+    $config->set('cooling', [ 0 ]);                 # to prevent speeds to be altered
     $config->set('first_layer_speed', '100%');      # to prevent speeds to be altered
     
     my $print = Slic3r::Test::init_print('20mm_cube', config => $config);
@@ -97,7 +97,7 @@ use Slic3r::Test;
     $config->set('support_material_speed', 99);
     $config->set('perimeter_extruder', 1);
     $config->set('support_material_extruder', 2);
-    $config->set('cooling', 0);                     # to prevent speeds to be altered
+    $config->set('cooling', [ 0 ]);                 # to prevent speeds to be altered
     $config->set('first_layer_speed', '100%');      # to prevent speeds to be altered
     
     my $print = Slic3r::Test::init_print('overhang', config => $config);