1 files changed, 177 insertions, 0 deletions
diff --git a/ArduinoAddons/Arduino_1.0.x/libraries/U8glib/utility/u8g_com_arduino_port_d_wr.c b/ArduinoAddons/Arduino_1.0.x/libraries/U8glib/utility/u8g_com_arduino_port_d_wr.c
new file mode 100755
index 000000000..64a8229e1
--- /dev/null
+++ b/ArduinoAddons/Arduino_1.0.x/libraries/U8glib/utility/u8g_com_arduino_port_d_wr.c
@@ -0,0 +1,177 @@
+/*
+  
+  u8g_arduino_port_d_wr.c
+
+  Universal 8bit Graphics Library
+  
+  Copyright (c) 2011, olikraus@gmail.com
+  All rights reserved.
+
+  Redistribution and use in source and binary forms, with or without modification, 
+  are permitted provided that the following conditions are met:
+
+  * Redistributions of source code must retain the above copyright notice, this list 
+    of conditions and the following disclaimer.
+    
+  * Redistributions in binary form must reproduce the above copyright notice, this 
+    list of conditions and the following disclaimer in the documentation and/or other 
+    materials provided with the distribution.
+
+  THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND 
+  CONTRIBUTORS "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, 
+  INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF 
+  MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE 
+  DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT HOLDER OR 
+  CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, 
+  SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT 
+  NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; 
+  LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER 
+  CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, 
+  STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) 
+  ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF 
+  ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.  
+  
+
+  Assumes PORTD for 8 bit data transfer.
+  EN is assumed to be a low active write signal (WR)
+
+  ILI9325D_320x240 from iteadstudio.com
+  RS=19, WR=18, CS=17, RST=16
+
+  
+  u8g_Init8Bit(u8g, dev, d0, d1, d2, d3, d4, d5, d6, d7, en, cs1, cs2, di, rw, reset)
+  u8g_Init8Bit(u8g, dev,  8,    9, 10, 11,   4,   5,   6,   7, 18, 14, 15, 17, 16, U8G_PIN_NONE)
+
+
+  Update for ATOMIC operation done (01 Jun 2013)
+    U8G_ATOMIC_OR(ptr, val)
+    U8G_ATOMIC_AND(ptr, val)
+    U8G_ATOMIC_START();
+    U8G_ATOMIC_END();
+
+*/
+
+#include "u8g.h"
+
+
+#if  defined(ARDUINO) && defined(PORTD)
+
+#if ARDUINO < 100 
+#include <WProgram.h> 
+#else 
+#include <Arduino.h> 
+#endif
+
+
+
+
+
+
+static void u8g_com_arduino_port_d_8bit_wr(u8g_t *u8g, uint8_t val)
+{
+  PORTD = val;
+  
+  /* WR cycle time must be 1 micro second, digitalWrite is slow enough to do this */
+  u8g_com_arduino_digital_write(u8g, U8G_PI_EN, LOW);
+  u8g_com_arduino_digital_write(u8g, U8G_PI_EN, HIGH);
+}
+
+
+uint8_t u8g_com_arduino_port_d_wr_fn(u8g_t *u8g, uint8_t msg, uint8_t arg_val, void *arg_ptr)
+{
+
+  switch(msg)
+  {
+    case U8G_COM_MSG_INIT:
+
+#ifdef UCSR0B
+      UCSR0B = 0;  // disable USART 0
+#endif
+      U8G_ATOMIC_START();
+      DDRD = 0x0ff;
+      PORTD = 0x0ff;
+      U8G_ATOMIC_END();
+
+      /* setup the RW pin as output and force it to low */
+      if ( u8g->pin_list[U8G_PI_RW] != U8G_PIN_NONE )
+      {
+        pinMode(u8g->pin_list[U8G_PI_RW], OUTPUT);
+        u8g_com_arduino_digital_write(u8g, U8G_PI_RW, HIGH);
+      }
+      /* set all pins (except RW pin) */
+      u8g_com_arduino_assign_pin_output_high(u8g);
+      u8g_com_arduino_digital_write(u8g, U8G_PI_EN, HIGH);
+      break;
+    case U8G_COM_MSG_STOP:
+      break;
+    case U8G_COM_MSG_CHIP_SELECT:
+      if ( arg_val == 0 )
+      {
+        /* disable */
+        u8g_com_arduino_digital_write(u8g, U8G_PI_CS1, HIGH);
+        u8g_com_arduino_digital_write(u8g, U8G_PI_CS2, HIGH);
+      }
+      else if ( arg_val == 1 )
+      {
+        /* enable */
+        u8g_com_arduino_digital_write(u8g, U8G_PI_CS1, LOW);
+        u8g_com_arduino_digital_write(u8g, U8G_PI_CS2, HIGH);
+      }
+      else if ( arg_val == 2 )
+      {
+        /* enable */
+        u8g_com_arduino_digital_write(u8g, U8G_PI_CS1, HIGH);
+        u8g_com_arduino_digital_write(u8g, U8G_PI_CS2, LOW);
+      }
+      else
+      {
+        /* enable */
+        u8g_com_arduino_digital_write(u8g, U8G_PI_CS1, LOW);
+        u8g_com_arduino_digital_write(u8g, U8G_PI_CS2, LOW);
+      }
+      break;
+    case U8G_COM_MSG_WRITE_BYTE:
+      u8g_com_arduino_port_d_8bit_wr(u8g, arg_val);
+      break;
+    case U8G_COM_MSG_WRITE_SEQ:
+      {
+        register uint8_t *ptr = arg_ptr;
+        while( arg_val > 0 )
+        {
+          u8g_com_arduino_port_d_8bit_wr(u8g, *ptr++);
+          arg_val--;
+        }
+      }
+      break;
+    case U8G_COM_MSG_WRITE_SEQ_P:
+      {
+        register uint8_t *ptr = arg_ptr;
+        while( arg_val > 0 )
+        {
+          u8g_com_arduino_port_d_8bit_wr(u8g, u8g_pgm_read(ptr));
+          ptr++;
+          arg_val--;
+        }
+      }
+      break;
+    case U8G_COM_MSG_ADDRESS:                     /* define cmd (arg_val = 0) or data mode (arg_val = 1) */
+      u8g_com_arduino_digital_write(u8g, U8G_PI_DI, arg_val);
+      break;
+    case U8G_COM_MSG_RESET:
+      if ( u8g->pin_list[U8G_PI_RESET] != U8G_PIN_NONE )
+        u8g_com_arduino_digital_write(u8g, U8G_PI_RESET, arg_val);
+      break;
+  }
+  return 1;
+}
+
+#else
+
+
+uint8_t u8g_com_arduino_port_d_wr_fn(u8g_t *u8g, uint8_t msg, uint8_t arg_val, void *arg_ptr)
+{
+  return 1;
+}
+
+#endif /* ARDUINO && PORTD */
+