diff options
Diffstat (limited to 'src/libslic3r/SLAPrint.cpp')
| -rw-r--r-- | src/libslic3r/SLAPrint.cpp | 15 |
1 files changed, 11 insertions, 4 deletions
diff --git a/src/libslic3r/SLAPrint.cpp b/src/libslic3r/SLAPrint.cpp index f45d805b6..1383acc40 100644 --- a/src/libslic3r/SLAPrint.cpp +++ b/src/libslic3r/SLAPrint.cpp @@ -407,6 +407,14 @@ sla::SupportConfig make_support_cfg(const SLAPrintObjectConfig& c) { scfg.tilt = c.support_critical_angle.getFloat() * PI / 180.0 ; scfg.max_bridge_length_mm = c.support_max_bridge_length.getFloat(); scfg.headless_pillar_radius_mm = 0.375*c.support_pillar_diameter.getFloat(); + switch(c.support_pillar_connection_mode.getInt()) { + case slapcmZigZag: + scfg.pillar_connection_mode = sla::PillarConnectionMode::zigzag; break; + case slapcmCross: + scfg.pillar_connection_mode = sla::PillarConnectionMode::cross; break; + case slapcmDynamic: + scfg.pillar_connection_mode = sla::PillarConnectionMode::dynamic; break; + } scfg.pillar_widening_factor = c.support_pillar_widening_factor.getFloat(); scfg.base_radius_mm = 0.5*c.support_base_diameter.getFloat(); scfg.base_height_mm = c.support_base_height.getFloat(); @@ -630,7 +638,7 @@ void SLAPrint::process() sla::PoolConfig pcfg(wt, h, md, er); ExPolygons bp; - double pad_h = sla::get_pad_elevation(pcfg); + double pad_h = sla::get_pad_fullheight(pcfg); auto&& trmesh = po.transformed_mesh(); // This call can get pretty time consuming @@ -724,9 +732,7 @@ void SLAPrint::process() po.m_supportdata->level_ids.reserve(sslices.size()); for(int i = 0; i < int(sslices.size()); ++i) { - int a = i == 0 ? 0 : 1; - int b = i == 0 ? 0 : i - 1; - LevelID h = sminZ + a * sih + b * slh; + LevelID h = sminZ + sih + i * slh; po.m_supportdata->level_ids.emplace_back(h); float fh = float(double(h) * SCALING_FACTOR); @@ -1058,6 +1064,7 @@ bool SLAPrintObject::invalidate_state_by_config_options(const std::vector<t_conf || opt_key == "support_head_penetration" || opt_key == "support_head_width" || opt_key == "support_pillar_diameter" + || opt_key == "support_pillar_connection_mode" || opt_key == "support_base_diameter" || opt_key == "support_base_height" || opt_key == "support_critical_angle" |