1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
|
use Test::More tests => 1;
use strict;
use warnings;
BEGIN {
use FindBin;
use lib "$FindBin::Bin/../lib";
use local::lib "$FindBin::Bin/../local-lib";
}
use List::Util qw(first);
use Slic3r;
use Slic3r::Flow ':roles';
use Slic3r::Geometry qw(PI scale unscale convex_hull);
use Slic3r::Surface ':types';
use Slic3r::Test;
{
my $config = Slic3r::Config::new_from_defaults;
$config->set('skirts', 0);
$config->set('perimeter_speed', 66);
$config->set('external_perimeter_speed', 66);
$config->set('small_perimeter_speed', 66);
$config->set('gap_fill_speed', 99);
$config->set('perimeters', 1);
$config->set('cooling', [ 0 ]); # to prevent speeds from being altered
$config->set('first_layer_speed', '100%'); # to prevent speeds from being altered
$config->set('perimeter_extrusion_width', 0.35);
$config->set('first_layer_extrusion_width', 0.35);
my $print = Slic3r::Test::init_print('two_hollow_squares', config => $config);
my @perimeter_points = ();
my $last = ''; # perimeter | gap
my $gap_fills_outside_last_perimeters = 0;
Slic3r::GCode::Reader->new->parse(Slic3r::Test::gcode($print), sub {
my ($self, $cmd, $args, $info) = @_;
if ($info->{extruding} && $info->{dist_XY} > 0) {
my $F = $args->{F} // $self->F;
my $point = Slic3r::Point->new_scale($info->{new_X}, $info->{new_Y});
if ($F == $config->perimeter_speed*60) {
if ($last eq 'gap') {
@perimeter_points = ();
}
push @perimeter_points, $point;
$last = 'perimeter';
} elsif ($F == $config->gap_fill_speed*60) {
my $convex_hull = convex_hull(\@perimeter_points);
if (!$convex_hull->contains_point($point)) {
$gap_fills_outside_last_perimeters++;
}
$last = 'gap';
}
}
});
is $gap_fills_outside_last_perimeters, 0, 'gap fills are printed before leaving islands';
}
__END__
|
