1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
|
use Test::More tests => 1;
use strict;
use warnings;
BEGIN {
use FindBin;
use lib "$FindBin::Bin/../lib";
}
use List::Util qw(first);
use Math::ConvexHull::MonotoneChain qw(convex_hull);
use Slic3r;
use Slic3r::Geometry qw(scale);
use Slic3r::Test;
{
my $config = Slic3r::Config->new_from_defaults;
$config->set('raft_layers', 2);
$config->set('infill_extruder', 2);
$config->set('support_material_extruder', 3);
$config->set('standby_temperature', 1);
$config->set('extruder_offset', [ [0,0], [20,0], [0,20] ]);
$config->set('temperature', [200, 180, 170]);
$config->set('first_layer_temperature', [206, 186, 166]);
my $print = Slic3r::Test::init_print('20mm_cube', config => $config);
my $tool = undef;
my @tool_temp = (0,0,0);
my @toolchange_points = ();
my @extrusion_points = ();
Slic3r::GCode::Reader->new->parse(Slic3r::Test::gcode($print), sub {
my ($self, $cmd, $args, $info) = @_;
if ($cmd =~ /^T(\d+)/) {
if (defined $tool) {
my $expected_temp = $self->Z == ($config->get_value('first_layer_height') + $config->z_offset)
? $config->first_layer_temperature->[$tool]
: $config->temperature->[$tool];
die 'standby temperature was not set before toolchange'
if $tool_temp[$tool] != $expected_temp + $config->standby_temperature_delta;
}
$tool = $1;
push @toolchange_points, Slic3r::Point->new_scale($self->X, $self->Y);
} elsif ($cmd eq 'M104' || $cmd eq 'M109') {
my $t = $args->{T} // $tool;
if ($tool_temp[$t] == 0) {
fail 'initial temperature is not equal to first layer temperature + standby delta'
unless $args->{S} == $config->first_layer_temperature->[$t] + $config->standby_temperature_delta;
}
$tool_temp[$t] = $args->{S};
} elsif ($cmd eq 'G1' && $info->{extruding} && $info->{dist_XY} > 0) {
push @extrusion_points, my $point = Slic3r::Point->new_scale($args->{X}, $args->{Y});
$point->translate(map scale($_), @{ $config->extruder_offset->[$tool] });
}
});
my $convex_hull = Slic3r::Polygon->new(@{convex_hull([ map $_->pp, @extrusion_points ])});
ok !(first { $convex_hull->encloses_point($_) } @toolchange_points), 'all toolchanges happen outside skirt';
}
__END__
|
