Merge remote-tracking branch 'origin/lm_temperature_fix'

1 files changed, 6 insertions, 2 deletions

diff --git a/xs/src/libslic3r/GCode/WipeTowerPrusaMM.cpp b/xs/src/libslic3r/GCode/WipeTowerPrusaMM.cpp
index 0427e32d6..61d8df035 100644
--- a/xs/src/libslic3r/GCode/WipeTowerPrusaMM.cpp
+++ b/xs/src/libslic3r/GCode/WipeTowerPrusaMM.cpp
@@ -529,6 +529,9 @@ WipeTower::ToolChangeResult WipeTowerPrusaMM::prime(
         ++ m_num_tool_changes;
     }
 
+    m_old_temperature = -1; // If the priming is turned off in config, the temperature changing commands will not actually appear
+                            // in the output gcode - we should not remember emitting them (we will output them twice in the worst case)
+
 	// Reset the extruder current to a normal value.
 	writer.set_extruder_trimpot(550)
 		  .feedrate(6000)
@@ -817,8 +820,9 @@ void WipeTowerPrusaMM::toolchange_Unload(
           .load_move_x_advanced(old_x,         -0.10f * total_retraction_distance, 0.3f * m_filpar[m_current_tool].unloading_speed)
           .travel(old_x, writer.y()) // in case previous move was shortened to limit feedrate*/
           .resume_preview();
-
-    if (new_temperature != 0 && new_temperature != m_old_temperature ) { 	// Set the extruder temperature, but don't wait.
+    if (new_temperature != 0 && (new_temperature != m_old_temperature || m_is_first_layer) ) { 	// Set the extruder temperature, but don't wait.
+        // If the required temperature is the same as last time, don't emit the M104 again (if user adjusted the value, it would be reset)
+        // However, always change temperatures on the first layer (this is to avoid issues with priming lines turned off).
 		writer.set_extruder_temp(new_temperature, false);
         m_old_temperature = new_temperature;
     }