diff options
Diffstat (limited to 'src/libslic3r/PrintObject.cpp')
| -rw-r--r-- | src/libslic3r/PrintObject.cpp | 7 |
1 files changed, 7 insertions, 0 deletions
diff --git a/src/libslic3r/PrintObject.cpp b/src/libslic3r/PrintObject.cpp index 6acaf5e86..fafb3347a 100644 --- a/src/libslic3r/PrintObject.cpp +++ b/src/libslic3r/PrintObject.cpp @@ -685,6 +685,7 @@ namespace Slic3r { || opt_key == "overhangs_width" || opt_key == "overhangs_reverse" || opt_key == "overhangs_reverse_threshold" + || opt_key == "perimeter_extrusion_spacing" || opt_key == "perimeter_extrusion_width" || opt_key == "infill_overlap" || opt_key == "thin_perimeters" @@ -695,6 +696,8 @@ namespace Slic3r { || opt_key == "external_perimeters_first" || opt_key == "external_perimeters_hole" || opt_key == "external_perimeters_nothole" + || opt_key == "external_perimeter_extrusion_spacing" + || opt_key == "external_perimeter_extrusion_width" || opt_key == "external_perimeters_vase" || opt_key == "perimeter_loop" || opt_key == "perimeter_loop_seam") { @@ -763,6 +766,7 @@ namespace Slic3r { || opt_key == "fill_density" || opt_key == "interface_shells" || opt_key == "infill_extruder" + || opt_key == "infill_extrusion_spacing" || opt_key == "infill_extrusion_width" || opt_key == "infill_every_layers" || opt_key == "infill_dense" @@ -793,6 +797,7 @@ namespace Slic3r { || opt_key == "infill_connection_solid" || opt_key == "infill_connection_top" || opt_key == "infill_connection_bottom" + || opt_key == "top_infill_extrusion_spacing" || opt_key == "top_infill_extrusion_width") { steps.emplace_back(posInfill); } else if ( @@ -804,6 +809,7 @@ namespace Slic3r { || opt_key == "no_perimeter_unsupported_algo" || opt_key == "perimeters" || opt_key == "perimeter_overlap" + || opt_key == "solid_infill_extrusion_spacing" || opt_key == "solid_infill_extrusion_width") { steps.emplace_back(posPerimeters); steps.emplace_back(posPrepareInfill); @@ -813,6 +819,7 @@ namespace Slic3r { steps.emplace_back(posPerimeters); steps.emplace_back(posSupportMaterial); } else if (opt_key == "bridge_flow_ratio" + || opt_key == "first_layer_extrusion_spacing" || opt_key == "first_layer_extrusion_width") { //if (m_config.support_material_contact_distance > 0.) { // Only invalidate due to bridging if bridging is enabled. |