From f6eafa4022dd61e029205bea4d4147d26e69fef2 Mon Sep 17 00:00:00 2001 From: Aswath Govindraju Date: Thu, 16 Dec 2021 09:40:11 +0530 Subject: dt-bindings: phy: ti,tcan104x-can: Document mux-states property On some boards, for routing CAN signals from controller to transceivers, muxes might need to be set. This can be implemented using mux-states property. Therefore, document the same in the respective bindings. Signed-off-by: Aswath Govindraju Reviewed-by: Rob Herring Signed-off-by: Rob Herring Link: https://lore.kernel.org/r/20211216041012.16892-2-a-govindraju@ti.com --- Documentation/devicetree/bindings/phy/ti,tcan104x-can.yaml | 7 +++++++ 1 file changed, 7 insertions(+) (limited to 'Documentation/devicetree') diff --git a/Documentation/devicetree/bindings/phy/ti,tcan104x-can.yaml b/Documentation/devicetree/bindings/phy/ti,tcan104x-can.yaml index 6107880e5246..02b76f15e717 100644 --- a/Documentation/devicetree/bindings/phy/ti,tcan104x-can.yaml +++ b/Documentation/devicetree/bindings/phy/ti,tcan104x-can.yaml @@ -37,6 +37,12 @@ properties: max bit rate supported in bps minimum: 1 + mux-states: + description: + mux controller node to route the signals from controller to + transceiver. + maxItems: 1 + required: - compatible - '#phy-cells' @@ -53,4 +59,5 @@ examples: max-bitrate = <5000000>; standby-gpios = <&wakeup_gpio1 16 GPIO_ACTIVE_LOW>; enable-gpios = <&main_gpio1 67 GPIO_ACTIVE_HIGH>; + mux-states = <&mux0 1>; }; -- cgit v1.2.3