From 59733ef7e510f6fd51a3dfc6f22ec1d3630a47b9 Mon Sep 17 00:00:00 2001 From: Christophe Leroy Date: Mon, 24 Sep 2012 08:19:03 +0200 Subject: Powerpc 8xx CPM_UART too many interrupts Setting the fifo to only 1 byte generates one interrupt every 1ms at 9600 bauds. This is too much. This patch reduces the threshold to speeds below 2400 bauds like in the 8250 UART driver. Signed-off-by: Christophe Leroy Acked-by: Alan Cox Signed-off-by: Greg Kroah-Hartman --- drivers/tty/serial/cpm_uart/cpm_uart_core.c | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) (limited to 'drivers/tty/serial/cpm_uart') diff --git a/drivers/tty/serial/cpm_uart/cpm_uart_core.c b/drivers/tty/serial/cpm_uart/cpm_uart_core.c index 46af6e47f061..46edc649b0b7 100644 --- a/drivers/tty/serial/cpm_uart/cpm_uart_core.c +++ b/drivers/tty/serial/cpm_uart/cpm_uart_core.c @@ -71,7 +71,7 @@ static void cpm_uart_initbd(struct uart_cpm_port *pinfo); /**************************************************************/ -#define HW_BUF_SPD_THRESHOLD 9600 +#define HW_BUF_SPD_THRESHOLD 2400 /* * Check, if transmit buffers are processed @@ -505,7 +505,7 @@ static void cpm_uart_set_termios(struct uart_port *port, pr_debug("CPM uart[%d]:set_termios\n", port->line); baud = uart_get_baud_rate(port, termios, old, 0, port->uartclk / 16); - if (baud <= HW_BUF_SPD_THRESHOLD || + if (baud < HW_BUF_SPD_THRESHOLD || (pinfo->port.state && pinfo->port.state->port.tty->low_latency)) pinfo->rx_fifosize = 1; else -- cgit v1.2.3