diff options
Diffstat (limited to 'doc/administration/high_availability/gitaly.md')
| -rw-r--r-- | doc/administration/high_availability/gitaly.md | 59 |
1 files changed, 2 insertions, 57 deletions
diff --git a/doc/administration/high_availability/gitaly.md b/doc/administration/high_availability/gitaly.md index 230f5baf33a..a1e8fe3b488 100644 --- a/doc/administration/high_availability/gitaly.md +++ b/doc/administration/high_availability/gitaly.md @@ -1,60 +1,5 @@ --- -stage: Create -group: Gitaly -info: To determine the technical writer assigned to the Stage/Group associated with this page, see https://about.gitlab.com/handbook/engineering/ux/technical-writing/#designated-technical-writers -type: reference +redirect_to: ../gitaly/index.md --- -# Configuring Gitaly for Scaled and High Availability - -A [Gitaly Cluster](../gitaly/praefect.md) can be used to increase the fault -tolerance of Gitaly in high availability configurations. - -This document is relevant for [scalable and highly available setups](../reference_architectures/index.md). - -## Running Gitaly on its own server - -See [Run Gitaly on its own server](../gitaly/index.md#run-gitaly-on-its-own-server) -in Gitaly documentation. - -Continue configuration of other components by going back to the -[reference architecture](../reference_architectures/index.md#configure-gitlab-to-scale) page. - -## Enable Monitoring - -> [Introduced](https://gitlab.com/gitlab-org/omnibus-gitlab/-/issues/3786) in GitLab 12.0. - -1. Make sure to collect [`CONSUL_SERVER_NODES`](../postgresql/replication_and_failover.md#consul-information), which are the IP addresses or DNS records of the Consul server nodes, for the next step. Note they are presented as `Y.Y.Y.Y consul1.gitlab.example.com Z.Z.Z.Z` - -1. Create/edit `/etc/gitlab/gitlab.rb` and add the following configuration: - - ```ruby - # Enable service discovery for Prometheus - consul['enable'] = true - consul['monitoring_service_discovery'] = true - - # Replace placeholders - # Y.Y.Y.Y consul1.gitlab.example.com Z.Z.Z.Z - # with the addresses of the Consul server nodes - consul['configuration'] = { - retry_join: %w(Y.Y.Y.Y consul1.gitlab.example.com Z.Z.Z.Z), - } - - # Set the network addresses that the exporters will listen on - node_exporter['listen_address'] = '0.0.0.0:9100' - gitaly['prometheus_listen_addr'] = "0.0.0.0:9236" - ``` - -1. Run `sudo gitlab-ctl reconfigure` to compile the configuration. - -<!-- ## Troubleshooting - -Include any troubleshooting steps that you can foresee. If you know beforehand what issues -one might have when setting this up, or when something is changed, or on upgrading, it's -important to describe those, too. Think of things that may go wrong and include them here. -This is important to minimize requests for support, and to avoid doc comments with -questions that you know someone might ask. - -Each scenario can be a third-level heading, e.g. `### Getting error message X`. -If you have none to add when creating a doc, leave this section in place -but commented out to help encourage others to add to it in the future. --> +This document was moved to [another location](../gitaly/index.md). |