diff options
Diffstat (limited to 'doc/administration/pages/source.md')
| -rw-r--r-- | doc/administration/pages/source.md | 12 |
1 files changed, 6 insertions, 6 deletions
diff --git a/doc/administration/pages/source.md b/doc/administration/pages/source.md index 87217b141a4..c7c25f0f3a7 100644 --- a/doc/administration/pages/source.md +++ b/doc/administration/pages/source.md @@ -1,12 +1,12 @@ --- stage: Release -group: Release Management -info: To determine the technical writer assigned to the Stage/Group associated with this page, see https://about.gitlab.com/handbook/engineering/ux/technical-writing/#designated-technical-writers +group: Release +info: To determine the technical writer assigned to the Stage/Group associated with this page, see https://about.gitlab.com/handbook/engineering/ux/technical-writing/#assignments --- # GitLab Pages administration for source installations -NOTE: **Note:** +NOTE: Before attempting to enable GitLab Pages, first make sure you have [installed GitLab](../../install/installation.md) successfully. @@ -77,7 +77,7 @@ host that GitLab runs. For example, an entry would look like this: where `example.io` is the domain under which GitLab Pages will be served and `192.0.2.1` is the IP address of your GitLab instance. -NOTE: **Note:** +NOTE: You should not use the GitLab domain to serve user pages. For more information see the [security section](#security). @@ -349,7 +349,7 @@ world. Custom domains and TLS are supported. ## NGINX caveats -NOTE: **Note:** +NOTE: The following information applies only for installations from source. Be extra careful when setting up the domain name in the NGINX configuration. You must @@ -395,7 +395,7 @@ API to check that the user is authorized to read that site. From [GitLab 12.8](https://gitlab.com/gitlab-org/omnibus-gitlab/-/merge_requests/3689) onward, Access Control parameters for Pages are set in a configuration file, which by convention is named `gitlab-pages-config`. The configuration file is passed to -pages using the `-config flag` or CONFIG environment variable. +pages using the `-config flag` or `CONFIG` environment variable. Pages access control is disabled by default. To enable it: |