diff options
Diffstat (limited to 'source/blender/bmesh/tools/bmesh_bevel.c')
| -rw-r--r-- | source/blender/bmesh/tools/bmesh_bevel.c | 10 |
1 files changed, 5 insertions, 5 deletions
diff --git a/source/blender/bmesh/tools/bmesh_bevel.c b/source/blender/bmesh/tools/bmesh_bevel.c index 36fe6ee655c..25459414cd7 100644 --- a/source/blender/bmesh/tools/bmesh_bevel.c +++ b/source/blender/bmesh/tools/bmesh_bevel.c @@ -3433,7 +3433,7 @@ static EdgeHalf *next_edgehalf_bev(BevelParams *bp, } normalize_v3(dir_new_edge); - /* Use this edge if it is the most parallel to the orignial so far. */ + /* Use this edge if it is the most parallel to the original so far. */ float new_dot = dot_v3v3(dir_new_edge, dir_start_edge); if (new_dot > best_dot) { second_best_dot = best_dot; /* For remembering if the choice was too close. */ @@ -4674,7 +4674,7 @@ static VMesh *pipe_adj_vmesh(BevelParams *bp, BevVert *bv, BoundVert *vpipe) f = (float)k / (float)ns; /* Ring runs along the pipe, so segment is used here. */ } - /* Place the vertex by interpolatin between the two profile points using the factor. */ + /* Place the vertex by interpolating between the two profile points using the factor. */ interp_v3_v3v3(mesh_vert(vm, i, j, k)->co, profile_point_pipe1, profile_point_pipe2, f); } else { @@ -6385,7 +6385,7 @@ static bool bev_rebuild_polygon(BMesh *bm, BevelParams *bp, BMFace *f) /* Edges in face are non-contiguous in our ordering around bv. * Which way should we go when going from eprev to e? */ if (count_ccw_edges_between(eprev, e) < count_ccw_edges_between(e, eprev)) { - /* Go counterclockewise from eprev to e. */ + /* Go counter-clockwise from eprev to e. */ go_ccw = true; } else { @@ -6419,7 +6419,7 @@ static bool bev_rebuild_polygon(BMesh *bm, BevelParams *bp, BMFace *f) BLI_array_append(ee, bme); } while (v != vend) { - /* Check for special case: multisegment 3rd face opposite a beveled edge with no vmesh. */ + /* Check for special case: multi-segment 3rd face opposite a beveled edge with no vmesh. */ bool corner3special = (vm->mesh_kind == M_NONE && v->ebev != e && v->ebev != eprev); if (go_ccw) { int i = v->index; @@ -7566,7 +7566,7 @@ void BM_mesh_bevel(BMesh *bm, } } - /* Perhaps clamp offset to avoid geometry colliisions. */ + /* Perhaps clamp offset to avoid geometry collisions. */ if (limit_offset) { bevel_limit_offset(&bp, bm); |