Slic3r has been modified to propagate the following filament specific

values to GCode generator, one per active extruder:

bed_temperature
bridge_fan_speed
cooling
disable_fan_first_layers
fan_always_on
fan_below_layer_time
first_layer_bed_temperature
max_fan_speed
min_fan_speed
min_print_speed
slowdown_below_layer_time

Now it remains to extend Slic3r to correctly apply these values.

1 files changed, 2 insertions, 2 deletions

diff --git a/t/fill.t b/t/fill.t
index 626144301..3c434ea52 100644
--- a/t/fill.t
+++ b/t/fill.t
@@ -199,7 +199,7 @@ for my $pattern (qw(rectilinear honeycomb hilbertcurve concentric)) {
     $config->set('infill_extruder', 2);
     $config->set('infill_extrusion_width', 0.5);
     $config->set('fill_density', 40);
-    $config->set('cooling', 0);                 # for preventing speeds from being altered
+    $config->set('cooling', [ 0 ]);             # for preventing speeds from being altered
     $config->set('first_layer_speed', '100%');  # for preventing speeds from being altered
     
     my $test = sub {
@@ -249,7 +249,7 @@ for my $pattern (qw(rectilinear honeycomb hilbertcurve concentric)) {
     $config->set('solid_infill_every_layers', 2);
     $config->set('perimeter_speed', 99);
     $config->set('external_perimeter_speed', 99);
-    $config->set('cooling', 0);
+    $config->set('cooling', [ 0 ]);
     $config->set('first_layer_speed', '100%');
     
     my $print = Slic3r::Test::init_print('20mm_cube', config => $config);